Fitting Instructions
Boil & Bite

THINGS YOU WILL NEED:

• Small Pot
• Water
• Stove
• TWG X mouthguard

Fitting Instructions:

1. Fill a small pot with water (3-4 inches). Place the pot on the stove and bring water to a boil.

2. Insert your TWG X mouthguard into the boiling water with a pair of tongs for approximately 90 seconds. DO NOT LEAVE IN LONGER OR DAMAGE TO THE MOUTHGUARD WILL OCCUR.

3. Turn off the stove and place the mouthguard in a container of cool water for 3-5 seconds

4. Place the mouthguard into your mouth (seating the mouthguard from front to back). Push the mouthguard upwards with your thumbs and then bite down. Begin conforming the mouth guard by pulling up and down on your cheeks on the front and sides of your face while continually sucking on your mouthguard. Allow the material to set for 1 minute in your mouth.

5. Remove the TWG X mouthguard and place on the counter for an additional 5 minutes to completely set.

Orthodontic Fitting Instructions:

*If you have braces, allow the material to set in your mouth for only 30 seconds teasing it (pulling it in and out your mouth half way to make sure the material doesn’t set directly around your brackets and wires) every ten seconds. It may then be reheated after every adjustment appointment, repeat the same setting time and instructions as before.

YOUR ARE NOW EQUIPED WITH THE TWG X ADVANTAGE! PLAY HARD, PLAY SAFE!

TWG X BUY NOW!!

Boil & Bite Mouth Guard Boil & Bite Mouth Guard Boil & Bite Mouth Guard Boil & Bite Mouth Guard Boil & Bite Mouth Guard
White/Clear Black/Clear Blue/Clear Light Pink/Clear Yellow/Clear
Boil & Bite Mouth Guard Boil & Bite Mouth Guard Boil & Bite Mouth Guard
Red/Clear Green/Clear Orange/Clear